Table of Contents
Advertisement
PARTS:
1.
Armrest Pad Bracket
2.
Hand Knob
3.
Armrest Bracket
4.
Arm Upright Assembly
5.
Washer
6.
Cap
7.
Screw
8.
Skirt Guard
9.
Screw (Allen)
10. Armpad Fixing Screws
11. Armrest Pad
No1 Phillips Screwdriver
Flat Headed Screwdriver
6mm Allen Key
INTRODUCTION
STEP 1
Check that the skirtguard is fixed and not physically damaged. If the panel is loose re-
tighten the fixing screw, install a new panel if necessary.
STEP 2
Check for armpad wear or damage. Replace if necessary.
STEP 3
Check for corrosion or paint damage to the bracketry and replace affected parts where
necessary.
DISMANTLING
STEP 1
Remove the handknob by rotating it anti-clockwise. Pull out the arm assembly.
STEP 2
Remove the two armpad fixing screws under the armpad and remove the armpad.
STEP 3
Remove the allen screw and pull out the armpad bracket.
STEP 4
Carefully remove the 2 caps with a flat headed screwdriver, remove the 2 phillips screws and
remove the skirtguard. Take care not to loosen the washers.
To re-assemble reverse step 4 to 1 taking care not to over tighten the fixing screws as this
could cause burrs and split the plastic washer.
Phoenix
11/01
ARM REST
3
2
9
4
1
11
1
8
10
7
6
5
Advertisement
Table of Contents
