Table of Contents
Advertisement
STEP 3
Deflate the tyre, locate, loosen and remove Socket Head Cap Screw securing the two halves of
the Wheel Rims together. Important note: Ensure the tyre is fully deflated before attempting
to separate to the two halves of the Wheel Rims.
STEP 4
Remove the tyre and tube.
STEP 5
To remove the Wheel Hub from the Axle Shaft locate loosen and remove the Wheel Hub Bolt
securing the Wheel Hub to the Axle Shaft.
STEP 6
Gently tap the wheel centre with a mallet and pull the wheel off the gear box shaft (take care not
to loose the key located in the gearbox shaft).
TO RE-ASSEMBLE
STEP 1
Re-fit the Wheel Hub to the gearbox shaft ensuring alignment of the keyway of the wheel centre
to the key fitted to gearbox shaft. Gently tap the wheel centre with a mallet until the threads can
be seen inside the shaft.
STEP 2
Fit the wheel bolt, ensuring that the washer has been fitted, to the gearbox shaft. Torque
rating of rear wheel bolt = 35 - 40Mm.
STEP 3
Locate tyre and tube to the face of the inside Rim that has the hole for the valve to seat in,
slightly inflate the tube.
STEP 4
Locate the other half of the Wheel Rim in position, insert Socket Cap Screws in position and pro-
ceed to tighten the screws. Ensure the inner tube is not trapped between the Wheel Rim halves.
Tighten securely Socket Head Cap Screws.
STEP 5
Inflate to the correct pressure as indicated on the Tyre Side Wall.
STEP 6
Position Wheel on Wheel Hub, locate and tighten Wheel Bolts securely.
Phoenix
7
11/01
Advertisement
Table of Contents
