Replacing The Batteries On Rc & Efc Models - Flavel Calibre FBFC**MN2 Installation, Maintenance & User Instructions

5.5.3 To operate the fire press and hold the "power" button as shown in figure
2 on the previous page for two seconds, release as soon as the red
indicator light in figure 2 on the previous page illuminates. The burner
will start its ignition sequence and light to the maximum heat input level.
5.5.4 To reduce the heat input, press and release the (-) button to lower the
heat input level one step at a time. Pressing the (-) button continuously
will move the heat input level to the minimum.
5.5.5 To turn the fire off, press the power button and the burner will stop.
5.5.6
If you are not intending to use the fire for a long period (i.e.
over the summer months) the battery life can be extended by
sliding the power isolator switch to the left (to the "0" position
away from the "1" position) on the valve itself, which is located
behind the ashpan cover on the fire.
5.6 REPLACING THE BATTERIES ON REMOTE CONTROL & EFC
MODELS
5.6.1 Remove the ashpan cover, locate the control valve battery cover at the
right hand side of the burner, slide the power isolator switch to the "0"
position (to the left).
5.6.2 Remove the battery cover and replace the 3 off AA batteries with good
quality Alkaline items, BFM Europe recommend the use of "Energizer"
batteries. It is important that only an alkaline battery is used,
otherwise premature battery failure and leakage may result.
5.6.3 Replace the battery cover and turn the power isolator switch to the "1"
position (to the right).
5.6.4 Replace the ashpan cover and operate the fire as normal.
5.6.5 On remote control models only fit two off AA batteries to the handset in
the direction shown inside the handset moulded into the plastic.
49