Removal Of The Control Valve (Mc Variants); Removal Of The Pilot Assembly (All Variants) - Flavel Calibre FBFC**MN2 Installation, Maintenance & User Instructions

4.3 Removing the control valve from the fire (manual control models
only)
4.3.1 Remove ash-pan, fret assembly / trim or fascia from the front of the fire.
4.3.2 Isolate the gas supply, remove the glass frame as shown on in section
2.10 then remove the ceramics. Remove the 2 off fixing screws which
hold the burner heat shield in place.
4.3.3 Remove the 4 off screws which hold the control panel in place and the
gas valve retaining nut.
4.3.7 Loosen and remove the three gas pipe retaining nuts from the control
valve and release the ends of the gas pipes from the control valve body.
Loosen and remove the thermocouple securing nut from the end of the
control valve.
4.3.8 We do not recommend re-greasing or servicing of control valves.
Defective valves should be replaced with a genuine replacement of the
correct type.
4.3.9 To refit a control tap, re-assemble in the reverse order noting that the
control tap locates on a flat in the control panel. Carry out a gas
tightness test after re-assembly.
4.4 Removing the pilot assembly (manual & remote control models)
4.4.1 Remove ash-pan, fret assembly / trim or fascia from the front of the fire.
4.4.2 Isolate the gas supply, remove the glass frame as shown on in section
2.10 then remove the ceramics. Remove the 2 off fixing screws which
hold the burner heat shield in place.
4.4.3 Loosen the pilot pipe, disconnect the ignition lead from the electrode,
and remove the thermocouple from the pilot body.
4.4.4 Remove the two fixing screws which secure the pilot assembly to the
mounting panel.
4.4.5 Remove the pilot assembly.
4.4.6 Re-assemble with an new pilot assembly, and gasket, ensuring than an
even seal around the pilot assembly is obtained. Carry out a gas
tightness test after re-assembly.
37