Advanced Settings Of Remote Control Models - Flavel Calibre FBFC**MN2 Installation, Maintenance & User Instructions

3.8.6
If you are not intending to use the fire for a long period (i.e.
over the summer months) the battery life can be extended by
sliding the power isolator switch to the left (to the "0" position
away from the "1" position) on the valve itself, which is located
behind the ashpan cover on the fire.
3.8.7 In the event of loss of the remote handset, as a backup the fire can
be controlled from the valve, which is located behind the ashpan
cover on the fire, see section 3.6 for full manual operating
instructions. If your fire does not operate manually please consult
the troubleshooting chart on the rear page of this manual.
3.8.8 If the handset is misplaced you can "page it" by pressing the (+) button
only on the control valve on the fire for a period of 5 seconds. The
handset will flash and make an audible noise to help you locate it.
Once you find the handset with one hand ensure your hand
is wrapped around the back and that your hand is in contact with both
sides of the handset then the audible noise will cease. The flashing
and sound will last for 60 seconds each time the handset is paged as
described. If not found in 60 seconds page the handset again until
located.
3.9 ADVANCED SETTINGS MENU OF THE REMOTE CONTROL
3.9.1 Snooze mode in manual operation
3.9.1.1 Snooze mode is a time period which can be set which will turn the fire
automatically off after a certain time period has elapsed.
3.9.1.2 Hold the handset with one hand ensuring your hand is wrapped around
the back and that your hand is in contact with both sides of the handset.
The green light of the "unlock" symbol should light. The snooze time
period can be set either before or during manual operation of the fire.
3.9.1.3 With the handset held as described above, press the mode button to
scroll through the functions until the symbols MAN and Zzz are
flashing at the top of the display as shown overpage in figure 28.
3.9.1.4 Press and release the set button and this will put the control into the
manual snooze mode.
3.9.1.5 The default time period in snooze mode is 1:00 hour.
29