Installing The Fixing Cleaning Belt - Canon NP6330 Service Manual

CHAPTER 6 FIXING SYSTEM

4. Installing the Fixing Cleaning Belt

The fixing cleaning belt consists of a feeding shaft, take-up shaft, and cleaning belt
constructed as a single entity (service part). Install the fixing cleaning belt by reversing
the steps used to remove it with the following in mind:
• Wind the cleaning belt two to three times around the cleaning belt take-up shaft.
At this time, check to make sure that the area that will come into contact with the
roller is impregnated with oil.
Note:
Check to make sure that the fixing cleaning belt is not wound askew or is free from
slack and wrinkling.
• After installing the fixing cleaning belt, insert a flatblade screwdriver in the fixing
cleaning belt drive shaft, and turn it counterclockwise until the cleaning belt is free
of slack.
Reference:
The fixing cleaner assembly is located above the fixing assembly and is used to
clean the surface of the upper roller by keeping the cleaning belt impregnated with
silicone oil against the roller. The cleaning belt is 15m long, and is given a marking
at a point 2.5m from its end.
Note:
If you have replaced the fixing cleaning belt, be sure to reset the reading of '619' in
counter mode (service mode) to '0'.
6-16
COPYRIGHT © 1997 CANON INC.
Download Service Manual And Resetter Printer at http://printer1.blogspot.com
Figure 6-410
CANON NP6330 REV.0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)