Scanner Assembly Removal - Lexmark X46x series Service Manual

7014-xxx
13.
Remove the kickstand (B).
14.
Remove the two flatbed supports (C). These will be used on the new flatbed.
15.
Remove the controller shield (D). This will be used on the new flatbed.

Scanner assembly removal

1.
Remove the left scanner cover. See
2.
Remove the right scanner cover. See
3.
Remove the left side cover. See
4.
Remove the right side cover. See
5.
Lift the flatbed and ADF assemblies to the up position.
6.
Remove the controller board shield. See
7.
Disconnect the HVPS cable from connector J37 on the controller board.
8.
Disconnect the front cover interlock switch cable from connector J11 on the controller board.
9.
Disconnect the stairway cables from J500 and J501 on the engine board.
4-88
B C
"Left scanner cover removal" on page
"Right scanner cover removal" on page
"Left side cover removal" on page
"Right side cover removal" on page
"Controller board shield" on page
D
4-100.
4-101.
4-33.
4-77.
4-11.