7014-xxx
Flatbed removal
1.
Remove the left side cover. See
2.
Remove the left scanner cover. See
3.
Remove the right scanner cover. See
4.
Remove the right side cover. See
5.
Remove the ADF unit. See
6.
Raise the flatbed unit to the up position.
7.
Remove the controller board shield. See
8.
Disconnect FBmtr from connector J28, FB home from connector J13, CCD from connector J30, and
Plegnth sensor cables from connector J12 on the controller board.
9.
Using a flatbed screwdriver, depress the lower tab on the kickstand, and lift the kickstand out of the left rear
frame assembly.
4-86
"Left side cover removal" on page
"Left scanner cover removal" on page
"Right scanner cover removal" on page
"Right side cover removal" on page
"ADF unit removal" on page
"Controller board shield" on page
4-33.
4-100.
4-101.
4-77.
4-85.
4-11.