ZyXEL Communications eircom D1000 User Manual page 82

Chapter 6 Home Networking
Figure 40 Network Setting > Home Networking > LAN Setup
The following table describes the fields in this screen.
Table 21 Network Setting > Home Networking > LAN Setup
LABEL
LAN IP Setup
IP Address
Subnet Mask
RIP Version
Direction
Multicast
IGMP Snooping
DHCP Server State
80
DESCRIPTION
Enter the LAN IP address you want to assign to your Device in dotted decimal
notation, for example, 192.168.1.254 (factory default).
Type the subnet mask of your network in dotted decimal notation, for example
255.255.255.0 (factory default). Your Device automatically computes the subnet mask
based on the IP Address you enter, so do not change this field unless you are
instructed to do so.
RIP (Routing Information Protocol) allows a router to exchange routing information
with other routers. Select the RIP version from RIP1 and RIP2-B/RIP2-M.
Use this field to control how much routing information the VDSL Router sends and
receives on the subnet. Select the RIP Direction from None, Both, IN Only and
OUT Only.
IGMP (Internet Group Multicast Protocol) is a network-layer protocol used to establish
membership in a multicast group. The Device supports IGMP v1/IGMP v2/IGMP
v3. Select None to disable it.
Select Enabled to activate IGMP Snooping. This allows the Device to passively learn
memberships in multicast groups. Otherwise, select Disabled to deactivate it.
eircom D1000 modem User's Guide