ZyXEL Communications eircom D1000 User Manual page 144

Chapter 12 Filter
Figure 97 Security > Filter > IP/MAC Filter
The following table describes the labels in this screen.
Table 53 Security > Filter > IP/MAC Filter
LABEL
Rule Type
Rule Type selection
IP / MAC Filter Rule Editing
IP / MAC Filter Rule Index
Active
Interface
Direction
Rule Type
Source IP Address
Subnet Mask
142
DESCRIPTION
Select White List to specify traffic to allow and Black List to specify traffic to
disallow.
Select the index number of the filter rule.
Use this field to enable or disable the filter rule.
Select the PVC to which to apply the filter.
Apply the filter to Incoming or Outgoing traffic direction.
Select IP or MAC type to configure the rule.
Use the IP Filter to block or allow traffic by IP addresses.
Use the MAC Filter to block or allow traffic by MAC address.
Enter the source IP address of the packets you wish to filter. This field is
ignored if it is 0.0.0.0.
Enter the IP subnet mask for the source IP address
eircom D1000 modem User's Guide