The Telnet Screen - ZyXEL Communications eircom D1000 User Manual

Chapter 24 Remote Management

24.3 The Telnet Screen

You can use Telnet to access the Device's command line interface. Specify which interfaces allow
Telnet access and from which IP address the access can come.
Click Maintenance > RemoteMGMT > Telnet tab to display the screen as shown.
Figure 135 Maintenance > RemoteMGMT > Telnet
The following table describes the labels in this screen.
Table 81 Maintenance > RemoteMGMT > Telnet
LABEL
Server Port
Server Access
Secured Client IP
Address
Apply
Cancel
198
DESCRIPTION
This displays the service port number for accessing the Device. If the number is grayed
out, it is not editable.
Select the interface(s) through which a computer may access the Device using this
service.
Note: It is recommended if you are allowing WAN access even temporarily to change the
default password (in Maintenance > User Account). To allow access from the
WAN, you will need to configure a WAN to Router firewall rule. See
page 34 for information on configuring firewall rules.
A secured client is a "trusted" computer that is allowed to communicate with the Device
using this service.
Select All to allow any computer to access the Device using this service.
Choose Range to just allow the computer(s) with an IP address in the range that you
specify to access the Device using this service.
Click this to save your changes.
Click this to restore your previously saved settings.
Section 3.7 on
eircom D1000 modem User's Guide