ZyXEL Communications eircom D1000 User Manual page 146

Chapter 12 Filter
Figure 98 Security > Filter > IPv6/MAC Filter
The following table describes the labels in this screen.
Table 54 Security > Filter > IPv6/MAC Filter
LABEL
Rule Type
Rule Type selection
IPv6 / MAC Filter Rule Editing
IPv6 / MAC Filter Rule Index
Active
Interface
Direction
Rule Type
Source IP Address
Source Prefix Length
Destination IPv6 Address
Destination Prefix Length
144
DESCRIPTION
Select White List to specify traffic to allow and Black List to specify traffic to
block.
Select the index number of the filter rule.
Use this field to enable or disable the filter rule.
Select the PVC to which to apply the filter.
Apply the filter to Incoming or Outgoing traffic direction.
Select IP or MAC type to configure the rule.
Use the IP Filter to block or allow traffic by IPv6 addresses.
Use the MAC Filter to block or allow traffic by MAC address.
Enter the source IPv6 address of the packets you wish to filter. This field is
ignored if it is ::.
Enter the prefix length for the source IPv6 address
Enter the destination IPv6 address of the packets you wish to filter. This field is
ignored if it is ::.
Enter the prefix length for the destination IPv6 address.
eircom D1000 modem User's Guide