Print Is Too Light; Toner Spots On The Print - IBM InfoPrint 20 User Manual

11. Consider replacing the fuser. See "Changing the Usage Kit" on page 104.

Print Is Too Light

Possible Causes
Economy mode is set on
Density is set too low
There is moisture in the paper
The toner cartridge is low on
toner
The toner cartridge is
damaged

Toner Spots on the Print

Possible Causes.
Paper does not meet
specification
The toner cartridge is
damaged
150
InfoPrint 20: User's Guide -- Web Version
v "Twinax Setup Menu" on page 96
v "IPDS Menu" on page 79
Actions You Should Take
Make sure economy mode is not set.
Check your print driver settings and also
see "Configuration (Config) Menu" on
page 72.
Reset it to a higher value if necessary.
See "Configuration (Config) Menu" on
page 72.
Load fresh, dry paper
Replace the toner cartridge (see
"Changing the Toner Cartridge" on
page 101
Replace the toner cartridge (see
"Changing the Toner Cartridge" on
page 101
Actions You Should Take
Use recommended paper (see "Selecting
Paper and Other Printable Material" on
page 25)
Replace the toner cartridge (see
"Changing the Toner Cartridge" on
page 101
Print Sample
Print Sample