To replace the usage kit, do the following:
1. Power off the printer.
2. Unplug the printer power cord from the wall outlet.
3. Remove the power cord from the back of the printer.
4. Remove the duplex unit if it is installed. See "Removing the Duplex Unit" on
page 123.
5. To remove the existing fuser, do the following:
a. Open the fuser cover.
b. Loosen the two thumbscrews as shown. The screws do not detach from
the fuser.
c. Holding the fuser by the handles, lift the right side of the fuser, slide the
fuser to the right to free the left end of the fuser from the clamp, and lift the
Chapter 7. Maintaining the Printer
105