Accessories - Rangemaster Nexus 110 Induction User's Manual & Installation Instructions

N WARNING!
Refer to Before You Start... chapter.
Fig. 2.29
Fig. 2.30
Fig. 2.32
Fig. 2.34
ArtNo.320-0015
Fitting the Handyack 1
Fig. 2.31
Fig. 2.33
ArtNo.320-0014 Handyrack on LH door
Fig. 2.35
ArtNo.320-0016
Fitting the handyrack 2
17

Accessories

Oven Shelves
The oven shelves (Fig. 2.29) are retained when pulled
forward but can be easily removed and refitted.
Pull the shelf forward until the back of the shelf is stopped by
the shelf stop bumps in the oven sides (Fig. 2.30).
Lift up the front of the shelf so the back of the shelf will pass
under the shelf stop and then pull the shelf forward
(Fig. 2.31).
To refit the shelf, line up the shelf with a groove in the oven
side and push the shelf back until the ends hit the shelf stop.
Lift up the front so the shelf ends clear the shelf stops, and
then lower the front so that the shelf is level and push it fully
back (Fig. 2.32).
The Handyrack
The Handyrack (Fig. 2.33) fits to the left-hand oven door
only. Food cooking on it is easy to attend to, because it is
accessible when the door is open.
The maximum weight that can be held by the Handyrack
is 5.5 kg (12 lb). It should only be used with the supplied
roasting tin, which is designed to fit the Handyrack. Any other
vessel could be unstable.
It can be fitted at two different heights. One of the oven
shelves must be removed and the other positioned to suit.
When the Handyrack is used in its highest position, other
dishes can be cooked on the bottom shelf position or base of
the oven.
When the Handyrack is used in its lowest position, other
dishes can be cooked on the second shelf position or base of
the oven.
To fit the Handyrack, locate one side of it on the door bracket
(Fig. 2.34).
Then spring the other side out to clip it onto the other
bracket (Fig. 2.35).