Rear Cover; Led Assy/ Led Assy Spring - Oki C711 Maintenance Manual

Oki Data CONFIDENTIAL

4.2.6 Rear cover

(1) Open the faceup tray.
(2) Remove the two screws
(3) As shown in fig 2, insert the minus driver into the hole A to disengage the claw A (2
place).
(4) Disengage the claw B (2 places) and pull the upper side of the rear cover
the direction of A.
(5) As shown in fig 3, push the lower side of the rear cover
and disengage the claw C (3 places) to remove the rear cover
Figure (1)
Claw B
Claw A
A
B
Claw C
Figure (3)
44205401TH Rev.1
(silver, No:42920406).
in the direction of B,
.
A
Claw B
Claw A
Claw C
Figure (2)

4.2.7 LED Assy/ LED Assy spring

(1) Open the top cover
(2) After removing the cable, as shown in fig 2, push the LED assy
direction of arrow. Take the hook A out firstly, and then take the hook B out, at
last remove the LED assy.
(At this time, the two springs
in
Hole A
Hole A
4. Component replacement
is removed with LED Assy .)
Top cover
Figure (2)
Hook B
Figure (1)
tightly in the
Hook A
Hook A
67 /