Table of Contents
Advertisement
6. ADDING STAPLES (OPTIONAL) (Cont.)
2
Slide out the saddle stitch unit carefully toward the
1
front.
2
3
3
Pull out the grip of the saddle stitch holder ( ) to-
ward you and turn it ( ) 90
4
tion of the arrow.
5
6
4
Remove the empty staple case and set a new one.
- Replace both staple cases with new ones.
- Do not remove the seal holding the staples before the staple
case is set in the cartridge.
7
5
Return the saddle stitch holder and the saddle stitch-
ing unit to their respective original positions.
8
6
Make sure that the finisher is attached to the copier
firmly and that A3, B4 or A4-R size paper is set in the
copier.
- If one of the above paper sizes is not set, test stapling can-
9
not be performed.
7
Close the lower cover of the finisher. Test stapling is
then automatically performed on a blank sheet.
10
- This operation is carried out to avoid empty stitching.
11
If test stapling fails to be performed and the following mes-
sage remains displayed, repeat the above procedure from
steps 1 to 7.
Set staple cartridge
12
9-24
WHEN THE GRAPHIC SYMBOLS FLASH ON THE TOUCH PANEL
o
clockwise in the direc-
Advertisement
Table of Contents
