Clearing Of Toner Counter - Toshiba e-studio 211c Operator's Manual

15. CLEARING OF TONER COUNTER

The message " ***** toner is low. Prepare new toner cartridge." appears when the remaining toner
becomes about 30%. For the proper timing of the appearance of this message, reset the number of
toner counter to 0 (zero) after the replacement of the toner cartridge with a new one. (In case of the
replacement with a new cartridge after the message "Install new ***** toner cartridge Press HELP" has
appeared, however, the number of toner counter is automatically reset to 0 (zero). So the procedure in
this page is not necessary.)
- For the proper timing of the appearance of the above message, note the following (1) and (2).
(1) Do not reset the number of the toner counter to 0 (zero) manually without the toner cartridge
replacement.
(2) Make sure to use a new toner cartridge at this replacement.
* The timing of appearance of this message changes depending on the contents of originals, functions
to use and environment that the copier is used in.
You can set not to display the message "***** toner is low. Prepare new toner cartridge." temporarily.
User selection (
1
Press the PROGRAM key to enter the programme
menu. Then press the CARTRIDGE REPLACE key.
- If the desired key is not shown, press the Pre key or Next
key to switch the screen.
2
Select the colour of the replaced cartridge and press
the SET key.
3 Press the YES key.
- The number of the counter of the colour toner cartridge
which has been replaced is reset to 0 (zero).
Page 6-17)
1
2
3
4
5
6
7
8
9
10
11
12
6-35