Motorola VC70N0 Product Reference Manual page 160

5 - 44 VC70 Vehicle Computer Product Reference Guide
From the VC70 Desktop, Tap
9.
VC70 and displays the Scanner Selection notification.
Tap ; a black screen with "
10. Yes
On the black screen, tap
11.
TelnetCE Client shows the following notification: "
12.
". Tap
Host Profile?
Enter the following Host Profile information:
13.
•
Indicates the name of the host profile. Usually, this is the name or alias of the host system with which
Alias:
the VC70 creates a Telnet session.
•
Indicates the type of emulation that the host system uses. Available Options: <IBM-5251-11>
Emulation:
<IBM-3278-2> <IBM-3279-2> <IBM-3279-2E> <VT100> <VT220> <HP>. Default: <IBM-5251-11>
•
Indicates the IP address or host name of the host system. Possible Values: Valid IP address of the
Address:
running terminal emulation or host name.
•
Indicates the TCP port on which the host system is listening for Telnet connections. Possible Values: 0 -
Port:
65535. Default: 23 for Telnet server.
•
Secure Shell (SSH) is a cryptographic network protocol for secure data communication. Check the
box if required.
encryption
Tap .
14. Save
NOTE If re-editing is required, tap Options > Configure > Host Profiles and enter default password: "system".
tap OK to continue.
Tap
15. Options > Connect Session 1
connected to the host system. The bar code data will show on the black screen. The bar code data will show
on the black screen.
To unpair the scanner for using it on other VC70, scan the Unpairing bar code.
Unpairing Bar Code
Figure 5-53
> Programs > TelnetCE
No host connection
Options > Connect Session 1
to continue.
Yes
On the Edit Host Profile box, verify the Alias name and tap
and scan a bar code to scan a bar code to verify that the scanner is properly
to start TelnetCE. TelnetCE Client launches on the
" indication shows.
.
No Host Profiles have been configured. Would you like to add a
Use SSH
.
Done