Figure 189 Connecting A Microfilter; Figure 190 Connecting A Microfilter And Y-Connector - ZyXEL Communications P-660HW-D User Manual

Appendix K Splitters and Microfilters
2 Connect a cable from the wall jack to the "wall side" of the microfilter.
3 Connect the "phone side" of the microfilter to your telephone as shown in the following
figure.
4 After you are done, make sure that your telephone works. If your telephone does not
work, disconnect the microfilter and contact either your local telephone company or the
provider of the microfilter.

Figure 189 Connecting a Microfilter

You can also use a Y-Connector with a microfilter in order to connect both your modem and a
telephone to the same wall jack without using a POTS splitter.
1 Connect a phone cable from the wall jack to the single jack end of the Y-Connector.
2 Connect a cable from the double jack end of the Y-Connector to the "wall side" of the
microfilter.
3 Connect another cable from the double jack end of the Y-Connector to the ZyXEL
Device.
4 Connect the "phone side" of the microfilter to your telephone as shown in the following
figure.

Figure 190 Connecting a Microfilter and Y-Connector

326
P-660HW-D User's Guide