Otist; Enabling Otist - ZyXEL Communications P-660HW-D User Manual

Table 37 Wireless LAN: Advanced (continued)
LABEL
Apply
Cancel

7.5 OTIST

In a wireless network, the wireless clients must have the same SSID and security settings as
the access point (AP) or wireless router (we will refer to both as "AP" here) in order to
associate with it. Traditionally this meant that you had to configure the settings on the AP and
then manually configure the exact same settings on each wireless client.
OTIST (One-Touch Intelligent Security Technology) allows you to transfer your AP's SSID
and WPA-PSK security settings to wireless clients that support OTIST and are within
transmission range. You can also choose to have OTIST generate a WPA-PSK key for you if
you didn't configure one manually.
OTIST replaces the pre-configured wireless settings on the wireless clients.

7.5.1 Enabling OTIST

You must enable OTIST on both the AP and wireless client before you start transferring
settings.
The AP and wireless client(s) MUST use the same Setup key.
7.5.1.1 AP
You can enable OTIST using the RESET button or the web configurator.
7.5.1.1.1 Reset button
If you use the RESET button, the default (01234567) or previous saved (through the web
configurator) Setup key is used to encrypt the settings that you want to transfer.
Hold in the RESET button for three to eight seconds.
If you hold in the RESET button too long, the device will reset to the factory
defaults!
P-660HW-D User's Guide
DESCRIPTION
Click Apply to save your changes to the ZyXEL Device.
Click Cancel to reload the previous configuration for this screen.
Chapter 7 Wireless LAN
113