Configuring Log Settings; Figure 146 View Log; Table 95 View Log - ZyXEL Communications P-660HW-D User Manual

Chapter 20 Logs

Figure 146 View Log

The following table describes the fields in this screen.

Table 95 View Log

LABEL
Display
Time
Message
Source
Destination
Notes
Email Log Now
Refresh
Clear Log

20.3 Configuring Log Settings

Use the Log Settings screen to configure to where the ZyXEL Device is to send logs; the
schedule for when the ZyXEL Device is to send the logs and which logs and/or immediate
alerts the ZyXEL Device is to record. See
To change your ZyXEL Device's log settings, click Maintenance > Logs > Log Settings. The
screen appears as shown.
Alerts are e-mailed as soon as they happen. Logs may be e-mailed as soon as the log is full.
Selecting many alert and/or log categories (especially Access Control) may result in many e-
mails being sent.
234
DESCRIPTION
The categories that you select in the Log Settings screen display in the drop-down
list box.
Select a category of logs to view; select All Logs to view logs from all of the log
categories that you selected in the Log Settings page.
This field displays the time the log was recorded.
This field states the reason for the log.
This field lists the source IP address and the port number of the incoming packet.
This field lists the destination IP address and the port number of the incoming
packet.
This field displays additional information about the log entry.
Click Email Log Now to send the log screen to the e-mail address specified in the
Log Settings page (make sure that you have first filled in the E-mail Log Settings
fields in Log Settings).
Click Refresh to renew the log screen.
Click Clear Log to delete all the logs.
Section 20.1 on page 233 for more information.
P-660HW-D User's Guide