Table of Contents
Advertisement
Additional printer setup
Removing a printer hard disk
Note: This task requires a flathead screwdriver.
Warning—Potential Damage: System board electronic components are easily damaged by static electricity. Touch
something metal on the printer before touching any system board electronic components or connectors.
1
Access the system board.
For more information, see "Accessing the system board" on page 28.
2
Unplug the printer hard disk interface cable from the system board, leaving the cable attached to the printer hard
disk. To unplug the cable, squeeze the paddle at the plug of the interface cable to disengage the latch before pulling
the cable out.
3
Remove the screws while holding the printer hard disk in place, and then remove the printer hard disk.
1
2
43
Advertisement
Table of Contents
