Lexmark C762 User Manual page 79

Message
Held Jobs May Be
Lost
Held Jobs May Not Be
Restored
Hole Punch Waste Full
Insert Staple Cartridge
Insert Tray <x>
Install <device> or
Cancel Job
Invalid Engine Code
Invalid Network <x>
Code
Invalid Standard
Network Code
ITU Maint
ITU/Fuser Maint
What this message means
The printer memory is too full to
continue processing print jobs.
The printer memory cannot restore
Print and Hold jobs from the printer
hard disk.
The hole punch box in the finisher is
full.
The staple cartridge in the finisher is
missing or is installed incorrectly.
The specified tray is either missing or
not fully inserted.
The printer is requesting that a
specified device be installed so it can
print a job.
The printer engine code has not been
programmed or is not valid.
The code in an internal print server is
not valid. The printer cannot receive
and process jobs until valid code is
programmed into the internal print
server.
The counter that tracks wear on the
image transfer unit has reached its
limit.
The counters that track wear on the
image transfer unit and fuser have
reached their limit.
79
What you can do
• Press Go to clear the message and
continue printing. The printer frees
memory by deleting the oldest held job
and continues deleting held jobs until
there is enough printer memory to
process the job.
• Press Stop to clear the message without
deleting any held jobs. The current job
may not print correctly.
• Press Menu to open the Job Menu and
cancel the current job.
• To avoid this error in the future:
– Delete fonts, macros, and other data
stored in printer memory.
– Install more printer memory.
Note: The messages 37
Insufficient Memory and Held
Jobs may be lost alternate on the
display.
See also: Holding a job in the
37 Insufficient Memory
Press Go to clear the message. Some of
the Print and Hold jobs stored on the disk
will not be restored.
See also: 37 Insufficient Memory
Empty the hole punch box.
• Correctly install the staple cartridge to
clear the message.
• Press Go to ignore the message and
continue printing without stapling.
Insert the specified tray completely into the
printer.
See also: Loading the trays
• Turn the printer off, install the specified
device, and restart the printer.
• Press Menu to open the Job Menu and
cancel the current job.
Call for service.
See also: Calling for service
Download valid code to the printer internal
print server.
Note: You can download network code
while this message is displayed.
Replace the image transfer unit.
Replace the image transfer unit and fuser.
printer;