Lexmark C762 User Manual page 78

Message
Disk Corrupted.
Reformat?
Disk Recovery
x/5 yyy%
Empty Hole Punch
Box
Enabling Menus
Engine Warming
Enter PIN:
=___
Fax <x>
Flushing Buffer
Formatting Disk
yyy%
Formatting Flash
Fuser Maint
What this message means
The printer has attempted a disk
recovery process and cannot repair
the disk.
The printer is attempting to recover the
hard disk. Disk recovery takes place in
five phases; the second line on the
operator panel display shows the
percent complete of the current phase.
The finisher hole punch waste box is
full.
The printer is responding to a request
to make the menus available to all
users.
The printer is preparing the fuser for
printing.
The printer is waiting for you to enter
your four-digit personal identification
number (PIN).
The printer is processing an incoming
fax.
The printer is flushing corrupted print
data and discarding the current print
job.
The printer is formatting the hard disk.
When formatting takes longer than
usual, the second line of the display
shows the percent complete.
The printer is formatting the flash
memory.
The counter that tracks wear on the
fuser has reached its limit.
78
What you can do
• Press Go to reformat the disk and delete
all files currently stored on the disk.
• Press Stop to clear the message without
reformatting the disk. The printer may
display Disk Recovery and attempt to
recover the disk.
See also: Disk Recovery x/5 yyy%
Wait for the message to clear.
Warning: Do not turn the printer off while
this message is displayed.
Remove the finisher hole punch box, empty
it, and then replace it.
Wait for the message to clear, and then
press Menu to view the menus from the
operator panel.
See also: Enabling the menus
Wait for the message to clear.
Use the operator panel buttons to enter the
PIN you identified in the driver when you
sent the confidential job to the printer.
See also: Holding a job in the printer
Wait for the message to clear.
Wait for the message to clear.
Wait for the message to clear.
Warning: Do not turn the printer off while
this message is displayed.
Wait for the message to clear.
Warning: Do not turn the printer off while
this message is displayed.
Replace the fuser.