2.10 Lan Setup; Table 2-7 Wan Setup Menu Fields - ZyXEL Communications Prestige 314 PLUS User Manual

Prestige 314 PLUS Broadband Sharing Gateway with 4-Port Switch
address will be copied to the rom file (ZyNOS configuration file). It will not change unless you change the
setting in menu 2 or upload a different rom file.
The following table contains instructions on how to configure your WAN setup.
FIELD
MAC Address
Assigned By Press the [SPACE BAR] to choose one of two methods to assign a
MAC Address. Choose Factory Default to select the factory assigned
default MAC Address. Choose IP Address attached on LAN to use
the MAC Address of that workstation whose IP you give in the
following field.
This field is applicable only if you choose the IP Address attached
IP Address
on LAN method in the Assigned By field above. Enter the IP
address of the workstation on the LAN whose MAC you are cloning.
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to Confirm..." to save
your configuration, or press [ESC] at any time to cancel.
Your Prestige WAN Port is always set at half-duplex mode as most cable modems only support half-duplex
mode. If your cable modem supports full-duplex mode, then you will be able to manually set it at half-duplex
mode. If the Prestige is set at half-duplex mode and the cable modem is set at full-duplex mode, then the
WAN port will not function properly.
Your Prestige supports full duplex mode on the LAN side.

2.10 LAN Setup

This section describes how to configure the LAN using Menu 3 — LAN Setup. From the main menu, enter
3 to display menu 3 (shown next).
2-14

Table 2-7 WAN Setup Menu Fields

DESCRIPTION
Hardware Installation & Initial Setup
EXAMPLE
IP Address
attached on
LAN
192.168.1.33