Wan Setup; Figure 2-9 Menu 2 - Wan Setup - ZyXEL Communications Prestige 314 PLUS User Manual

Password Enter the password assigned to you.
Enable Wildcard Your Prestige supports DYNDNS Wildcard. Press [SPACE
BAR] to select Yes or No.
This field is only available when CustomDNS is selected in the
Offline
DDNS Type field. Press [SPACE BAR] and then [ENTER] to
select Yes. When Yes is selected, traffic is redirected to a URL
that you have previously specified (see www.dyndns.org for
details).
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to Confirm..." to save
your configuration, or press [ESC] at any time to cancel.
The IP address will be updated when you reconfigure menu 1 or perform DHCP client renewal. If you have
a private WAN IP address, then you cannot use Dynamic DNS.
2.9

WAN Setup

This section describes how to configure the WAN using Menu 2 – WAN Setup. From the main menu, enter
2 to display menu 2.
ZyXEL recommends you configure this menu even if your ISP does not require
Press Space Bar to Toggle
The MAC address field allows users to configure the WAN port's MAC Address by either using the factory
default or cloning the MAC address from a workstation on your LAN. Once it is successfully configured, the
Hardware Installation & Initial Setup
Prestige 314 PLUS Broadband Sharing Gateway with 4-Port Switch
MAC address authentication.
Menu 2 - WAN Setup
MAC Address:
Assigned By= Factory default
IP Address= N/A
Press ENTER to Confirm or ESC to Cancel:
Figure 2-9 Menu 2 — WAN Setup
Yes
Yes
2-13