Printing Photos From A Pictbridge-Enabled Digital Camera - Lexmark 101 User Manual

Printing photos from a PictBridge-enabled digital camera

PictBridge is a technology available in most digital cameras that lets you print directly from your digital camera without
using a computer.
1
Insert one end of the USB cable into the camera.
Note: Use only the USB cable that came with the camera.
2
Insert the other end of the cable into the PictBridge port on the front of the printer.
Notes:
•
Make sure that the PictBridge-enabled digital camera is set to the correct USB mode. If the camera USB selection
is incorrect, then the camera is detected as a flash drive, or an error message will be displayed on the printer
control panel. For more information, see the camera documentation.
•
The printer reads only one memory device at a time.
3
If the PictBridge connection is successful, then the following message appears on the display: PictBridge
Camera detected. Press OK to change settings.
4
Press to access the PictBridge menu.
5
Press the arrow buttons to select the paper size, paper type, photo size, and layout of the photos that you want to
print. Press each time you make a selection.
6
See the documentation for your camera to begin printing.
Note: If you insert the camera while the printer is performing another job, then wait for the job to finish before printing
from the camera.
Warning—Potential Damage: Do not touch the USB cable, any network adapter,
any connector, the memory device, or the printer in the areas shown while actively
printing, reading, or writing from the memory device. A loss of data can occur.
Printing
42