Setting The Number Of Rings Before Receiving A Fax Automatically; Setting Up To Fax While Behind A Pbx - Lexmark X502N User Manual

To set the volume for any of the above settings:
1
From the control panel, press
2
Press or repeatedly until Machine Settings appears, and then press
3
Press or repeatedly until Speaker Volume appears, and then press
4
Press or repeatedly until the volume setting you want appears, and then press
5
Press or repeatedly until the volume level you want appears, and then press
Note: Volume levels range from 0–3, with 0 being silent and 3 being the loudest volume. The factory default
setting is 0.
6
Press to return to the Ready state.

Setting the number of rings before receiving a fax automatically

The Ring Count Delay sets the number of times the phone line rings before the printer answers in Fax Only mode.
If you have extension phones on the same line as the printer, or subscribe to the telephone company's Distinctive
Ring service, keep the Ring Count Delay setting at 4.
1
From the control panel, press
2
Press or repeatedly until Fax Settings appears, and then press
3
Press or repeatedly until RX Settings appears, and then press
4
Press or repeatedly until Ring Count Delay appears, and then press
5
Press or repeatedly to set how many times the phone line rings before the printer answers (0–99), and
then press .
6
Press to return to the Ready state.
When the number of rings you set is detected, the printer automatically receives the incoming fax. Set the Ring Count
Delay to 0 to disable the line from ringing.

Setting up to fax while behind a PBX

If the printer is being used in a business or office, it may be connected to a Private Branch Exchange (PBX) telephone
system. Ordinarily, when dialing a fax number, the printer waits to recognize the dial tone and then dials the fax
number. However, this method of dialing may not work if the PBX telephone system uses a dial tone that is not
recognizable to most fax machines. PBX Selection enables the printer to dial the fax number without waiting to
recognize the dial tone.
1
From the control panel, press
2
Press or repeatedly until Admin Settings appears, and then press
3
Press or repeatedly until PBX Selection appears, and then press
4
Press or repeatedly until the type of PBX connection you want appears, and then press
5
Press to exit the PBX selection menu.
6
Press or repeatedly until PBX Access Digit appears, and then press
.
.
.
68
.
.
.
.
.
.
.
.
.
.
.