Mac Filters - D-Link DIR-620 User Manual

DIR-620 Multifunction Wireless Router Supporting WiMAX, 3G GSM/CDMA
with Built-in Switch
User Manual
When you have configured the parameters, click the Change button.

MAC Filters

On the MAC Filters tab, you can define a set of MAC addresses of devices which will be allowed
to access the WLAN, or define MAC addresses of devices which will not be allowed to access the
WLAN.
By default, MAC filtering is not active (the Disabled choice of the MAC Restrict Mode radio
button is selected).
To add a MAC addresses to which the selected filtering mode will be applied, enter this address in
the Add MAC Address field and click the Change button. After that, the entered address will be
displayed in the MAC address table on the left part of the tab.
To remove a MAC address from the MAC address table, select the checkbox located to the left of
the relevant MAC address in the table and click the Delete button.
To open your wireless network for the devices which MAC addresses are displayed in the table and
to close the wireless network for all other devices, select the Allow choice of the MAC Restrict
Mode radio button.
To close your wireless network for the devices which MAC addresses are displayed in the table,
select the Deny choice of the MAC Restrict Mode radio button.
Figure 38. MAC filters for the wireless network.
Page 56 of 107
Configuring via Web-based Interface