D-Link DIR-620 User Manual page 39

DIR-620 Multifunction Wireless Router Supporting WiMAX, 3G GSM/CDMA
with Built-in Switch
User Manual
Parameter
Service name
Dial on demand
MTU
PPP IP extension
Keep Alive
Use Static IP Address
PPP debug
PPPoE pass through
Interface
Enable IGMP Multicast
Enable RIP
NAT
Firewall
When all needed settings are configured, click the Save button.
The name of the PPPoE authentication server.
Select the checkbox if you want the router to establish connection to
the Internet on demand. In the Maximum idle time field, specify a
period of inactivity (in seconds) after which the connection should be
terminated.
The maximum size of units transmitted by the interface.
This option is used by some ISPs. Contact your ISP to clarify if this
checkbox needs to be enabled.
Select the checkbox if you want the router to
your ISP even when the connection has been inactive for a specified
period of time. When the checkbox is selected, the LCP interval
and LCP fails fields are available. Specify the required values.
Select the checkbox if you want to use a static IP address to access
the Internet. In the IP Address field displayed when the checkbox
is selected, specify a static IP address.
Select the checkbox if you want to log
debugging.
Select the checkbox if you want to allow PPPoE clients of computers
from your LAN to connect to the Internet through this PPPoE
connection of the router.
The name assigned to the connection by the system.
Miscellaneous
Select the checkbox to allow multicast traffic from the external
network (e.g. video streaming) to be received.
Select the checkbox to allow using RIP for this connection.
Select the checkbox if you want one WAN IP address to be used for
all computers of your LAN.
Select the checkbox to enable protection against ARP and DDoS
attacks.
Page 39 of 107
Configuring via Web-based Interface
Description
keep you connected to
all data on PPP connection