Gateway 910 Series System Manual page 46

5
Locate an empty socket, then pull open the socket latch on each side of
the DIMM socket.
6
Align the two notches on the DIMM with the two notches in the DIMM
socket, then insert the new DIMM into the socket.
7
Gently press the DIMM into the socket until it is firmly seated. Inserting
the DIMM automatically locks the socket latch on each end of the DIMM.
8
Reinstall the cover panel. (See "Reinstalling the cover panel" on page 22.)
9
Reconnect external devices, the power cord(s), and the modem cable (if
installed), then turn on the server.
To replace DIMMs:
1
Observe the safety and ESD precautions in "Preventing static electricity
discharge" on page 15.
2
Turn off the server, then disconnect the power cord(s), modem cable (if
installed), and all external devices.
3
Remove the cover panel. (See "Removing the cover panel" on page 17.)
38
Replacing or Adding System Components
Socket latch
Socket
Socket notches