Adding A 5.25-Inch Or 3.5-Inch Removable Media Drive - Gateway 910 Series System Manual

Adding a 5.25-inch or 3.5-inch removable
media drive
You can use the additional, externally accessible, upper drive cage to install
(1-inch height and 1.6-inch half-height) 5.25-inch or 3.5-inch removable
media drives, such as a tape drive, a CD-RW drive, or a high capacity disk
storage drive. This procedure covers adding both types of drives.
To install an additional drive:
1
Observe the safety and ESD precautions in "Preventing static electricity
discharge" on page 15.
2
Turn off the server, then disconnect the power cord(s), modem cable (if
installed), and all external devices.
3
Remove the cover panel. (See "Removing the cover panel" on page 17.)
4
Remove the bezel. (See "Removing the bezel" on page 19.)
5
Remove the appropriate plastic bezel insert covering the drive bay by
pressing the retaining tab and pulling the insert out from the back of
the bezel. Save the insert so that you can replace it if you remove the
added drive.
30
Replacing or Adding System Components
5.25-inch insert
3.5-inch insert