Nikon Coolpix 8700 Repair Manual page 45

10-2. 1.5-m Adjustment
※ For 1.5-m adjustment, it is necessary to (re)write the adjustment firmware, so before the adjustment, be sure to
(re)write the firmware. Also, after completing the adjustment, do NOT forget to restore the original product firmware.
Procedure for setting Adjustment firmware
1) Save the adjustment firmware and the product firmware in any folder.
2) Start up "DscCalDi130c" and click on "Firmware" button on the main menu to write the adjustment firmware.
(If the camera is activated after completing writing the adjustment firmware, "SERVICE" is indicated in red
letters on LCD panel.)
3) Follow the instructions of the below [How-to].
4) Start "DscCalDi130c" and click "Firmware" on the main menu to write the product firmware.
[Preparations]
• Set the Siemens star chart.
• Turn the power switch of the camera to on.
[Conditions]
• The siemens star chart should be A3-size or larger (Copy and enlarge A4-size siemens chart included in the
service manual for the usage.)
• Illumination over the object should be 400 lux ± 10%
• Set the siemens star chart and the camera (front surface of lens) at 150 cm ± 3 cm distance between them.
[How-to]
• Double click on "DscCalDi130c".
• Set the siemens star chart so that it comes center of the screen by checking through the viewfinder.
• Click "Focus" then "Yes".
• Lens adjustment values will appear on the screen.
Judgment standard: xd0 = 0 ± 50, xd12 = 0 ± 50, xd19 = 0 ± 50 xd31 = 0 ± 50
• Click "OK".
Camera
カメラ
150cm±3cm
Siemens star chart
ジーメンス
スターチャート
- A25 ･ E8700 -
"Yes"
VAA26001-R.3627.A
Result of adjustment