Installing A Controller - Fujitsu PRIMERGY TX300 S3 Options Manual

Installing a controller

9.1 Installing a controller
Ê Open the server as described in the
2
1
Figure 59: Removing the rear cover
Ê Push the green fastening slider toward the rear (1).
Ê Remove the PCI slot's rear cover (2).
V
CAUTION!
Keep the rear cover of the PCI slot for future use. If you remove the
controller again and do not replace it with a new one, the rear cover
must be reinstalled to comply with EMC regulations and to satisfy
cooling requirements and fire protection measures.
68
Controller in non-hot-plug PCI slots
chapter "Preparation" on page
Options Guide
17ff.
TX300 S3