Fujitsu PRIMERGY TX300 S3 Options Manual page 54

Installing a slimline CD/DVD drive
Figure 42: Inserting CD/DVD drive in the frame
Ê Connect the data cable to the rear side of the slimline CD/DVD drive (see the
cabling plans in the Appendix).
Ê Insert the slimline CD/DVD drive in the frame. The four noses will fasten the
frame.
Ê Slide the slimline CD/DVD drive into the mounting location until it latches in
place. Take care that the data cable does not clamp.
Ê Connect the power cable to the rear side of the slimline CD/DVD drive (see
the cabling plans in the Appendix).
I
If a slimline floppy disk drive or a LocalView module has been installed
above the slimline CD/DVD drive, it is not possible to get access to the
power connector of the slimline CD/DVD drive. In this case pull out the
slimline floppy disk drive or the LocalView module as far as you get
access to the power connector.
54 Options Guide
Accessible drives
TX300 S3