Fujitsu PRIMERGY TX300 S3 Options Manual page 78

Converting from the floorstand model to the rack model
Figure 67: Installing the operating panel module
Ê Push the operating panel module halfway into the upper bay of the drive
cage.
Ê Connect the I2C cable, the ribbon cable and USB cable to the operating
panel module.
Ê Now push the operating panel module fully into the upper bay of the drive
cage.
Ê Turn the drives removed beforehand through 90° to the left.
Ê Turn the dummy covers removed beforehand through 90° to the left.
Ê Install the drives and empty covers in the drive cage.
Ê Reestablish all connections to the drives.
Ê Reinstall the ventilation duct over the system fans (see
Ê Attach the rack front cover, close the server, connect it to the power outlet,
and switch it on as described in the
To enable the rack model to be presented correctly in ServerView, proceed as
follows:
Ê Place the ServerStart CD-ROM in the drive.
Ê Under the path \Tools\System Configuration start the SCU_Chassis Model
Conversion program and change the server type to "PRIMERGY TX300S3
Rack".
78
chapter "Completion" on page
Options Guide
page 39).
79ff.
TX300 S3