Bowflex Xtreme Assembly Instructions & Owner's Manual page 10

8
Step 5: Install the Squat Pulley Frame
Locate the following items:
• Squat Pulley Frame (Item #10)
• Assembly Frame (From Step 4)
• (2) 3/8" X 1" Button Head Screws (Item #C)
• (1) 3/8" X 5" Button Head Screw (Item #F)
• (4) 3/8" Washers (Item #K)
• (1) 3/8" Nylock Nut (Item #O)
Place the Squat Pulley Frame (Item #10) behind the Seat Support
Rail as shown in Figure E, and line up the holes in the Squat
Pulley Frame with the holes in the Seat Support Rail.
Firmly secure the Squat Attachment Bracket to the Seat Support
Rail using (1) 3/8" X 5" Button Head Screw (F) with (2) 3/8"
Washers (K) - one on each side of the Seat Support Rail, and (1)
3/8" Nylock Nut (O) on the upper hole (see Figure E) and (2)
3/8" X 1" Button Head Screw (C) and (2) 3/8" Washers (K) on
the lower holes (one per side).
Step 6: Attach the Pulley Arms and Slider Pulleys
Locate the following items:
• Right and Left Pulley Arms (Items #8 and #9)
• Slider Pulley w/Cable Assembly (Item #16)
• (4) 3/8" X 3/4" Button Head Screws (Item #B)
• (4) 3/8" Washers (Item #K)
• (2) 1/4" X 1/2" Cap Screw (Item #H)
Place the Right Pulley Arm (Item #8) onto the right side
connector on the Base Frame/Lat Tower Assembly (from Step 5)
(see Figure F.)
Use (2) 3/8" Washers (K) over (2) 3/8" X 3/4" Button Head
Screws (B) - one washer per screw - to loosely secure the Pulley
Arm to the Frame Rail. Repeat for Left Pulley Arm (Item #9).
Position one Slider Pulley (Item #16) over the end of each Pulley
Arm. Choose any of the four holes. Secure (1) 1/4" X 1/2" Cap
Screw (H) through the hole on the underside of the Pulley Arm.
Assembly Guide
Base Frame &
Lower Lat Tower
F
C
10
Figure E
Figure F
8
16
Assembly
K
B
K
K
O
C
H
B