Add A Policy Routing Entry - D-Link DFL-900 User Manual

Part III
NAT & Routing

8.4.2 Add a policy routing entry

Step 1. Setup the ISP2 link
We must add an IP alias record to the WAN1
port because a new ISP link has been applied.
So. See section 3.4.3 for the full procedures.
Here we add an IP alias of WAN1 as
210.2.1.1/255.255.255.248.
Step 2. Insert a policy routing entry
Click Insert button to add a policy routing entry.
Step 3. Fill out the related field
For the General-Manager-Room department, we
need to set an extra policy routing entry for them.
So in the Status region, make sure the
Activate this rule is enabled, and then fill in
GenlManaRoom in the Rule name field. In
the Condition region, we fill 192.168.40.192
in Source IP field. Fill 255.255.255.192 in the
Netmask field. In the Action region, fill forward
to WAN1 with next-hop gateway 210.2.1.6. After
setting as above, the packets which match the
condition, they will follow the predefined action to
forward to the next hop.
D-Link
Basic Setup > WAN Settings > IP Alias
Advanced Settings > Routing > Policy Route
Advanced Settings > Routing > Policy Route > Insert
76