Setup Dmz1, Lan1 Status - D-Link DFL-900 User Manual

Part II
Basic Configuration
Get DNS
Automatically /
DNS IP Address
Disconnect
button

3.4.2 Setup DMZ1, LAN1 Status

Step 1. Setup DMZ port
Here we are going to configure the DMZ1
settings. Setup IP Address and IP Subnet
Mask, and determine if you would like to enable
the DHCP Server. And then select Routing
Protocol. Click Apply to finish this setting.
FIELD
IP Address
IP Subnet Mask
Enable DHCP Server
IP Pool Starting Address
Pool Size(max size: 253)
Primary DNS Server
Secondary DNS Server
Lease time(sec)
Routing Protocol
D-Link
Get DNS Automatically à Get DNS related
information from PPPoE ISP
DNS IP Address à manually specify these
Primary and
information
Through click Disconnect button to disconnect
PPPoE link
Table 3-1 Detailed information of setup WAN port configuration
BASIC SETUP > DMZ Settings > DMZ1 Status
DESCRIPTION
DMZ port IP address
DMZ port IP subnet mask
Enable DMZ port of the DHCP Sever or not
Specify the starting address of the DHCP IP address.
Specify the numbers of the DHCP IP address.
Specify the Primary DNS Server IP address of the DHCP
information.
Specify the Secondary DNS Server IP address of the DHCP
information.
Specify DHCP information lease time
Determine to enable the dynamic routing protocol (RIP), to
receive RIP message, to send out RIP message if the
message is received or not.
Secondary DNS Server
36
Get DNS
Automatically /
Automatically
DNS IP Address
Disconnect Click Disconnect
Range / Format EXAMPLE
IPv4 format 10.1.1.254
netmask format 255.255.255.0
Enable/Disable
IPv4 format in the
DMZ address
range
1 ~253
IPv4 format 10.1.1.254
IPv4 format
greater than 0
None / RIPv1In /
RIPv1In+out /
RIPv2In /
RIPv2In+out /
OSPF
Get DNS
Enabled
10.1.1.1
20
0.0.0.0
7200
None