Radius Setting; Ldap Setting - D-Link DFL-900 User Manual

Part II
Basic Configuration

6.3.4 Radius Setting

Step 1. Configure Radius Settings
If you have configured RADIUS support and a
user is required to authenticate using a RADIUS
server, the DFL-1500 then will contact the
RADIUS server for authentication.
Click Authentication Type as Radius. Enter
Port and enter the
Server IP/Server
RADIUS Server Secret. Click Apply to store
the settings.
FIELD
Server IP The IP address of the RADIUS server.
Server Port The port which the data goes into or out of the RADIUS server.
Secret is the encryption key used by RADIUS to send authentication
Secret
information over a network.

6.3.5 LDAP Setting

Step 1. Configure LDAP Settings
If you have configured LDAP support and a user
is required to authenticate using a LDAP server,
the DFL-1500 will then contact the LDAP server
for authentication. To authenticate with the
DFL-1500, the user enters a username and
password. The DFL-1500 sends this user name
and password to the LDAP server. If the LDAP
server can authenticate the user, the user is
successfully authenticated with the DFL-1500.
Click Authentication Type as LDAP. Enter
LDAP and
Server IP
distinguished name (Base DN) used to look up
entries on the LDAP server. For example, you
can use the Base DN like ou=people,
dc=yourcompany,dc=com,dc=tw where ou is
organization unit and dc is domain component.
Enter the common name identifier in the UID
field. Note that UID (it may be named as cn) is
the field name in LDAP server. Please refer to
Table 6-4 for details.
FIELD
Server IP The IP address of the LDAP server.
The distinguished name used to look up entries on the LDAP server. For
Base DN
example:
D-Link
Basic Setup > Authentication > Authentication > Radius
DESCRIPTION
Table 6-3 RADIUS Settings
Basic Setup > Authentication > Authentication > LDAP
then enter the
DESCRIPTION
58
EXAMPLE
192.168.40.60
1812
wall
EXAMPLE
192.168.40.66
ou=people,dc=yourcompany,
dc=com,dc=tw