Engine Maintenance; Servicing The Air Cleaner - Toro Z580-D Z Master Operator's Manual

Engine Maintenance

Servicing the Air Cleaner

Note: Check the filters more frequently if operating
conditions are extremely dusty or sandy.
Removing the Air Filter
Service Interval: Every 250 hours
1. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Release the latches on the air cleaner and pull the air
cleaner cover off of the air cleaner body (Figure 39).
4. Clean the inside of the air cleaner cover with
compressed air.
5. Gently slide the filter out of the air cleaner body
(Figure 39). Avoid knocking the filter into the side
of the body.
6. Inspect the filter for damage by looking into the
filter while shining a bright light on the outside of
the filter. Holes in the filter will appear as bright
spots. If the filter is damaged discard it.
1. Air filter body
2. Air filter
Installing the Air Filter
1. If installing a new filter, check the filter for shipping
damage. Do not use a damaged filter.
2. Carefully slide the filter into the filter body
(Figure 40). Ensure that it is fully seated by pushing
on the outer rim of the filter while installing it.
Important: Do not press on the soft inside area
of the filter.
3. Install the air cleaner cover and secure the latches
(Figure 40).
35
Figure 39
3. Air cleaner cover
4. Latches