Adjusting The Flow Baffle - Toro Z580-D Z Master Operator's Manual

3. After adjusting the height-of-cut, adjust the rollers
by removing the flange nut, bushing, spacer, and
bolt (Figure 20 , Figure 21 and Figure 22 ).
Note: The two middle rollers will not have a spacer
(Figure 21).
4. Select a hole so the anti-scalp roller is positioned to
the nearest corresponding height-of-cut desired.
5. Install the flange nut bushing, spacer, and bolt.
Torque to 40-45 ft-lb (54-61 N-m) (Figure 20 ,
Figure 21 and Figure 22 ).
6. Repeat this adjustment on the other anti-scalp
rollers.
Figure 20
1. Anti-scalp roller
2. Spacer
3. Bushing
Figure 21
1. Anti-scalp roller
2. Bushing
4. Flange Nut
5. Bolt
3. Flange Nut
4. Bolt
1. Anti-scalp roller
2. Spacer
3. Bushing

Adjusting the Flow Baffle

The mower discharge flow can be adjusted for different
types of mowing conditions. Position the cam locks
and baffle to give the best quality of cut.
1. Disengage the PTO, move the motion control
levers to the neutral locked position and set the
parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. To adjust the cam locks, swing the lever up to
loosen the cam lock (Figure 23).
4. Adjust the baffle and cam locks in the slots to the
desired discharge flow.
5. Swing the lever back over to tighten the baffle and
cam locks (Figure 23).
6. If the cams do not lock the baffle into place or it is
too tight, loosen the lever and then rotate the cam
lock. Adjust the cam lock until the desired locking
pressure is achieved.
1. Cam lock
2. Lever
25
Figure 22
4. Flange Nut
5. Bolt
Figure 23
3. Rotate cam to increase or
decrease locking pressure
4. Slot