Positioning The Flow Baffle; Using The Lift Assist Lever - Toro Z580-D Z Master Operator's Manual

Positioning the Flow Baffle

The following figures are only recommendations for
use. Adjustments will vary by grass type, moisture
content, and height of grass.
Note: If the engine power draws down and the mower
ground speed is the same, open up the baffle.
Position A
This is the full rear position. The suggested use for this
position is a follows (Figure 24).
• Use for short, light grass mowing conditions.
• Use in dry conditions.
• For smaller grass clippings.
• Propels grass clippings farther away from the
mower.
Figure 24
Position B
Use this position when bagging.
Figure 25
Position C
This is the full open position. The suggested use for
this position is as follows.
• Use in tall, dense grass mowing conditions.
• Use in wet conditions.
• Lowers the engine power consumption.
• Allows increased ground speed in heavy conditions.
• This position is similar to the benefits of the Toro
SFS mower.

Using the Lift Assist Lever

The lift assist lever is used along with the height-of-cut
lever for raising the mower deck. This allows for easier
raising of the mower deck.
1. Place your foot onto lift assist lever.
2. Press on the lift assist lever while pulling up on the
height-of-cut lever (Figure 27).
26
Figure 26
Figure 27