Inspecting The Blades; Removing The Blades - Toro Z580-D Z Master Operator's Manual

Before Inspecting or Servicing the
Blades
Park the machine on a level surface, disengage the blade
control (PTO), and set the parking brake. Turn the
ignition key to Off. Remove the key.

Inspecting the Blades

Service Interval: Before each use or daily
1. Inspect the cutting edges (Figure 84). If the edges
are not sharp or have nicks, remove and sharpen the
blades. Refer to Sharpening the Blades.
2. Inspect the blades, especially the curved area
(Figure 84). If you notice any damage, wear, or a slot
forming in this area (Figure 84), immediately install a
new blade.
Figure 84
1. Cutting Edge
2. Curved Area
Checking for Bent Blades
1. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Rotate the blades until the ends face forward and
backward (Figure 85). Measure from a level surface
to the cutting edge, position A, of the blades
(Figure 85). Note this dimension.
3. Wear/slot Forming
4. Crack
1. Measure here from blade
to hard surface
4. Rotate the opposite ends of the blades forward.
5. Measure from a level surface to the cutting edge of
the blades at the same position as in step 3 above.
The difference between the dimensions obtained in
steps 3 and 4 must not exceed 1/8 inch (3 mm). If
this dimension exceeds 1/8 inch (3 mm), the blade
is bent and must be replaced; refer to Removing the
Blades and Installing the Blades.
WARNING
A blade that is bent or damaged could break
apart and could seriously injure or kill you or
bystanders.
• Always replace bent or damaged blade with
a new blade.
• Never file or create sharp notches in the
edges or surfaces of blade.

Removing the Blades

Blades must be replaced if a solid object is hit, if the
blade is out of balance or is bent. To ensure optimum
performance and continued safety conformance of
the machine, use genuine Toro replacement blades.
Replacement blades made by other manufacturers may
result in non-conformance with safety standards.
WARNING
Contact with a sharp blade can cause serious injury.
Wear gloves or wrap sharp edges of the blade with
a rag.
59
Figure 85
2. Position A