Storing The Tyre Sealant And Compressor Kit - Chevrolet 2015 Corvette Owner's Manual

excess pressure by pressing
the pressure deflation
button (4) until the proper
pressure reading is reached.
This option is only functional
when using the air only
hose (7).
11. Press the on/off button (2) to
turn the tyre sealant and
compressor kit off.
Be careful while handling the
tyre sealant and compressor kit
as it could be warm after
usage.
12. Unplug the power plug (8) from
the accessory power outlet in
the vehicle.
13. Disconnect the air only hose
(7) from the tyre valve stem, by
turning it anticlockwise, and
replace the tyre valve
stem cap.
14. Replace the air only hose (7)
and the power plug (8) and
cord back in its original
location.
15. Place the equipment in the
original storage location in the
vehicle.
The tyre sealant and compressor kit
has an accessory adapter located in
a compartment on the bottom of its
housing that may be used to inflate
air mattresses, balls, etc.
Removal and Installation of the
Sealant Canister
To remove the sealant canister:
1. Unwrap the sealant hose.
Vehicle Care
2. Press the canister release
button (9).
3. Pull up and remove the canister.
4. Replace with a new canister
which is available from your
dealer.
5. Push the new canister into
place.
Storing the Tyre Sealant
and Compressor Kit
The tyre sealant and compressor
kit, if equipped, should be stored in
the storage area behind the left rear
wheel opening in the rear
compartment when it is not
being used.
To access the storage area:
1. Open the hatch/boot. See Hatch
(Boot) on page 2-11.
10-69