Operation; Control Panel Operation; Menu Map; Dmx Linking - Chauvet Sgocker 90 IRC User Manual

4. O
PERATION
Control Panel

Operation

Menu Map

DMX Linking

Configuration
(DMX)

Starting Address

Shocker™ 90 IRC User Manual Rev. 1
To access the control panel functions, use the four buttons located underneath the display.
Please refer to the Product Overview
Button
Press to find an operation mode or to back out of the current menu
<MENU>
option
<UP>
Press to scroll up the list of options or to find a higher value
<DOWN>
Press to scroll down the list of options or to find a lower value
<ENTER>
Press to activate a menu option or a selected value
Mode Programming Steps
2-CH
DMX Personality and
5-CH
Starting Address
8-CH
Auto Programs P--
Program Speed S--
Custom U--
Sound-Active Snd
Sound Sensitivity SenS
Infrared SET
Temperature
The Shocker™ 90 IRC works with a DMX controller. Information about DMX is in the
CHAUVET® DMX Primer,
http://www.chauvetlighting.com/downloads/DMX_Primer_rev05_WO.pdf.
Set the product in DMX mode to control with a DMX controller.
1. Connect the product to a suitable power outlet.
2. Connect a DMX cable from the DMX output of the DMX controller to the DMX input
socket on the product.
When selecting a starting DMX address, always consider the number of DMX channels the
selected DMX mode uses. If you choose a starting address that is too high, you could
restrict the access to some of the product's channels.
The Shocker™ 90 IRC uses up to 8 DMX channels, which defines the highest configurable
address to 505.
If you are not familiar with the DMX protocol, download the DMX Primer from
www.chauvetlighting.com.
To select the starting address, do the following:
1. Press <MENU> repeatedly until the desired DMX mode (2-CH, 5-CH, or 8-CH) shows
on the display.
2. Press <ENTER> and d 0-d512 will show on the display.
3. Use <UP> or <DOWN> to select the starting address.
4. Press <ENTER>.
to see the button locations on the control panel.
Function
Selects the DMX personality and starting
d 1–d512
address
P 0–P 7 Selects auto programs 0–7
Sets auto program speed
S 1–S100
Sets dimmer (0–100%)
d 0–d255
S 0–S255 Selects the strobe speed, slow to fast (0–28 Hz)
Snd1
Sets the Sound-Active mode
Snd2
u 0–u100 Selects the sound sensitivity
ON
Turns Infrared mode on or off
OFF
Temp
Shows current temperature of the product
which is available
Description
from the Chauvet website
Page 9 of 18