System Maintenance - Oki MC361 Service & Troubleshooting Manual

Menu
Fax
Maintenance
*This menu not shown
on models with no fax.
Print Maintenance

2.3 System Maintenance

OKIUSER
Sets the MFP for the Destination Country.
Should always be set for ODA (North America). Settings other than ODA may
Note!
result in erratic MFP operation. When the screen exits the service menu after this setting
is changed, the MFP reboots automatically.
Format SD Card
A confirmation message is displayed when the Enter switch is pressed.
When "No" has been selected, the system returns to the previous menu.
When "Yes" has been selected, the menu is exited and formatting of the inserted SD card
begins.
Displayed under the following conditions:
SD card inserted ("Boot Menu" - "Storage Setup" - "Enable SD Card" is Yes)
Format Flash ROM
Caution! Use of this command is strictly prohibited (contact design before use).
When this command is executed, the menu is exited and formatting of the resident
(onboard) flash device begins.
Reset Admin Password
Returns the administrator password to the factory default value.
All Reset
Returns the content of EEPROM, flash, and the HDD to their factory default values.
When this command is executed, the following confirmation message is displayed: "This
change will reboot the device automatically. Proceed?"
When "No" has been selected, the system returns to the previous menu.
When "Yes" has been selected, the menu is exited immediately and then, after rebooting,
reset processing begins. See the "format scope" sheet for the scope of formatting.
Item 1
Service Bit
Country Code
Line Test
T.30 Monitor
Personality
Engine Diag Mode
Item 2
Tone Send Test
DP Send Test
MF Send Test
Modem Signal Send
Test
Execute
IBM 5577
IBM PPR III XL
EPSON FX
Item 3
12