Oki MC361 Service & Troubleshooting Manual page 34

2. Press the button and the following message appears. Press
[6]
target option appears.
3. Press the button, and the displayed test option is performed:
[6]
When
DENS ADJ EXECUTE
a. A density adjustment test starts (the ONLINE lamp starts blinking).
b. When the test ends, the upper display shows the result of the test (OK or
an error name), the lower display shows ****RESULT.
Pressing the next test result. Pressing
[2]
Pressing restores the state for step 2.
[4]
c. Pressing the
ONLINE lamp), restoring the state for step 2.
When
DENS ADJ RESULT
Same button operation as (b) used when REG ADJ EXECUTE is executed.
When
DENS ADJ PAR-SET
The setting for the density adjustment parameter is displayed.
When
AUTO CALIBRATION
a. The density sensor sensitivity correction value is automatically set (the
ONLINE lamp starts blinking).
b. When the test ends, the upper display shows the result of the test (OK or
an error name), the lower display shows ****RESULT.
Pressing displays the next test result. Pressing
[2]
result. Pressing
c. Pressing the
ONLINE lamp), restoring the state for step 2.
Remark: While the printer is initialized or issues an alarm or the cover is open, it
displays the following message:
is executed:
button during the test cancels the test (turning on the
[#]
is executed:
is executed:
is executed:
restores the state for step 2.
[4]
button during the test cancels the test (turning on the
[#]
[2]
displays the preceding test result.
[8]
displays the preceding test
[8]
or until a
[8]
34