Table of Contents
Advertisement
EXTERNAL LIFT LEVER - - Fig. 17
For operations controlled from ground level use the
external control lever (1) fig. 17, lifting the lever from
its housing.
--
move the lever in the direction of arrow A to lower
the link arms;
--
move in direction fo arrow B to raise the link
arms.
CAUTION: before leaving the tractor seat to operate
the external control lever (1), check that:
- -
the parking brake is applied;
- -
the gear shift and range levers are in neutral;
- -
the PTO is disengaged;
- -
the engine is running at idle speed;
- -
the draft control lever (2) fig. 18 is fully forward.
DANGER: when using lever 1, ensure no- -
one is within the operating range of the imple-
ment connected to the lift. Never stand between the
implement and the rear of the tractor.
POSITION CONTROL
--
Move draft control lever (2) fig. 18 fully forward.
--
Set the position of the implement, either in or
above the ground, by moving the position control
lever (1) fig. 18 forward to lower and rearwards
to raise. The movement of the implement will be
proportional to the movement of the lever.
--
Press latch (2) fig. 19 in the direction of the arrow
to raise the implement at the headland. Fully
press switch (1) fig. 19 on the Lift--O--Matic
lower the implement, when required, without
having to use the lift control lever.
SECTION 3 - - FIELD OPERATIONS
TM
, to
TRE0813A
2
2
A
B
17
1
18
1
19
3--19
Advertisement
Table of Contents
